🏁After the measurements

Things to do when you finished with one sample or shift is over

1. Switch off analyzer electronics and close the beamline valves (starting from Beamshutter). For a short break (e.g. while changing samples) it is enough to close experimental valve and beamshutter;

2. Move manipulator to Preparation chamber;

3. Close valve between the chambers;

4. Close the needle valve of liquid helium transfer line;

5. Open the valve on the helium dewar to helium recovery line (or connect it);

6. Stop helium pump ("FP Helium" button on the panel at the back side of 1^2 frame);

If you are leaving:

1. Remove all the unnecessary marks on the screens;

2. Remove sample names from the magnets on the wall;

3. Remove files from desktop to your User folder;

4. Don't forget your samples and return sample plates if possible.